(laoslaser part 3) Connecting the to laos board LS3020

Stuff i did so far on my LS3020 to LaosLaser build

– moved the yellow and green wires so that yellow is on “Laser ON E” and green is on “Laser ON C”

– replaced stepperstick with pololu’s (others had problems)
– tried to connect both mainboard MBED en LCD to usb de MBED responded normally but the LCD did not (so both 5V and 24V are needed)
– wanted to check the serial info again but had some troubels using “screen” command on my mac (yes i am a terminal noob)
– now i am using coolterm
– and that works fine and has a UI 😉
– almost al test work but the steppers do not seem to work in a normal way maybe they are not getting enough current
– sdcard some times works and sometimes it does not weird
– tried to brun a hole but that was only posible with the potentiometer (that regulates the current) also weird

O well maybe this weekend more fun

Leave a Reply